GESTETNER DSC38 PRINTER DRIVER DOWNLOAD

Plug in the power cable. B With the 2 Tray Fnisher Tray laid horizontally, slide it in at a slant until it stops. Page 40 Setting Up Remove two screws that are fas- tening the Controller Board on the back of the printer using pro- vided screwdriver. Adjust the four corners of the printer to those of the sheet Large Capacity Tray, and then lower the printer slowly into place. Unit grasp the ba r inside the groove of the stand. Table of Contents Add to my manuals Add. Safety Information Safety Information When using your equipment, the following safety precautions should always be followed.

Uploader: Mazuran
Date Added: 4 May 2017
File Size: 42.23 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 21694
Price: Free* [*Free Regsitration Required]

Setting Up Test Printing Test print in order to check that the printer prints normally. Install the External Tray to the printer. Adjust the four corners of the printer to those of the sheet Paper Feed Unit, and then lower the printer slowly into place.

DSc38 Downloads | Ricoh Global

A sticker, stating that paper for an ink-jet printer cannot be used with this printer, is supplied. Remove the adhesive tape. A mal- function may occur due to overheating. Close Tray 1 slowly. Push the 2 Tray Finisher slowly toward the printer until it stops. Page 33 Fasten one thumb screw. Remove the ventilator to replace the in- ternal dustproof filter.

  HT1250 PROGRAMMING CABLE DRIVER

Gestetner DSc38 Manuals

C Fasten the Fnisher Tray with a short screw using provided screwdriver. Open the right cover of the sheet Paper Feed Unit. Also See for DSc38 Administrator’s manual – 20 pages.

Don’t show me this message again. Setting Up Align all four sides of the paper stack, and then load it in the tray.

Unit grasp the ba r inside the groove of the stand. Page 36 Setting Up Fasten one thumb screw. Page 63 Holding both sides of the 4-bin Mailbox with both hands, stand on the left side of the printer. Connect the other end to the host computer.

Gestetner DSc38 Setup Manual

Please at- tach the sticker to the bottom right corner of the top of the printer [A] so that sticker is easy to see. Setting Up Parallel Connection Use an interface cable to connect the printer to the host computer with a parallel connection.

Slide Tray 2 back into the printer slowly until it stops. Page 40 Setting Up Remove two screws that are fas- tening dsc3 Controller Board on the back of the printer using pro- vided screwdriver.

  MT5634ZBA USB DRIVER DOWNLOAD

Gestetner DSc Yellow Toner Cartridge (OEM) 10, Pages

Page 64 Install the External Tray to the printer. Adjust the Controller Board to the top and bottom rails, and then push in slowly until it stops. Comments gesttener this Manuals Your Name. Setting Up Insert the rail, assembled in stepinto the bottom area of the printer. This printer contains a laser beam generator and direct exposure to laser beams can cause permanent eye damage. For details on each option, lrinter Administrator Reference 2. Insert the rail with a wheel in the mounting bracket.

This space is necessary to operate the printer. Remove the two small covers on the upper left cover of the printer. Printer Hard Disk is shown on the panel display.

Setting Up Unpacking the Printer Remove the adhesive tape on the printer body. Do not attempt any maintenance or troubleshooting other than that mentioned in this manual.

Page 31 Fasten the bracket with the other thumb screw.